[Next] [Previous] [Up] [Top] [Contents] [Back] |
Chapter 3 Installation Procedures
3.4 Spindle Sync OptionWhen two drives of the same manufacturer and type are used then the spindle synchronization option can be activated.
Figure 3-3 Spindle Sync Option
When a jumper is placed on pins 7 and 8 of P14, the spindle synchronization signal of drive 1 is connected to the spindle synchronization signal of drive 2. Note that further SCSI commands to the drives are needed to make the spindle synchronization option active.
BI-0316 - Mass Storage Module - 6 DEC 1996 Copyright © 1996 Brand Innovators B.V. [Next] [Previous] [Up] [Top] [Contents] [Back]