[Next] [Previous] [Up] [Top] [Contents] [Back] |
Chapter 3 Installation Procedures
3.2 SCSI Bus ID SelectionA SCSI bus supports 8, 16 or 32 devices depending on the cable width used. Each device must have an unique SCSI ID assigned. The SCSI IDs of the devices fitted can be selected using the switches available on the BI0316.
Figure 3-1 ID Selection
The device ID selection for each drive is accomplished using a hex rotary DIP switch. The SCSI ID of drive 1 in position 1 is set with switch SW1, the SCSI ID of drive 2 is set with SW2. For 8-bit devices IDs 0 to 7 are used, for 16-bit devices IDs 0 to F are valid.
BI-0316 - Mass Storage Module - 6 DEC 1996 Copyright © 1996 Brand Innovators B.V. [Next] [Previous] [Up] [Top] [Contents] [Back]